BEC Audio dmc1 Betriebsanleitung PDF herunterladen (Seite 12)

dmc1

2861 Congressman Lane | Dallas, Texas 75220 | 800.877.6631 | www.mssystems.com

Page

Satellite Speakers

At each speaker location, strip approximately 4 Inches of jacket from the

MS2SXSC cables and separate the colored wires from each other. Strip

1/2 Inch of insulation from each wire. Connect the

MS2SXSC cable to the speaker as shown in figure 8.

NOTE: The bare drain wire from the cable is not

connected and should be cut off. On speakers

equipped with RED and BLACK terminals, connect the

BLUE wire to the BLACK terminal and the VIOLET

wire to the RED terminal.

Amplifier Mounting

The amplifier module will install on a single vertical stud previously

marked during rough-in. The vertical height of the

amplifier will allow complete coverage over the wall

openings for the remote volume controls and control

panel wiring. Mark the location of the top mounting

keyhole and bottom mounting holes. With the amplifier

removed verify the location of the vertical stud by

installing the enclosed mounting screws at the marked

locations. Once the location of the stud has

been verified, remove the screws. Remove

the cover from the amplifier. While positioning the amplifier (with cover

removed) into position, bring the volume control and preamp cabling

through the holes provided. Secure the amplifier to the wall in the

Figure 13 – Stereo

irin

connections

Figure 14 – Mono

irin

connections

Figure 16 – Speaker

connections

Figure 17

–

Amplifier mounting

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

BEC Audio dmc1 Betriebsanleitung Seite 12